Command Line Arguments

To use command line arguments, create a shortcut of the built .exe, then right click > properties then add any arguments to the 'Target' text field.

The following command line arguments can be used

argument	use
-igloo3DEnabled	Enables 3D Mode on start
-iglooSpoutReset	Enables sending a reset message '/spout/reset' via OSC on creation to port 9001
-iglooSenderName [NAME]	Where the following [NAME] argument specifies the spout sharing name
-iglooCameraType [NAME]	Where the following [NAME] argument specifies the type of camera and must be one of the following Cylinder Cube Unwrap Cylinder6 ImmersiveRoom4
-setNDI	Sets the output mode of all camera systems to NDI rather than Spout
-setVsync0/1/2	Set's vsync count in quality settings
-setTargetFPS	Set's the fps target, default is 60 frames per second.
-iglooFOV [NAME]	Where [NAME] argument specifies the FOV type. Standard Wide SuperWide
-setResolution 7680x500	ImmersiveRoom4 only sets the resolution for the system. Default is 7680x500.

Igloo 360 Camera Technical Docs