Controls when using a Headset

General Interactions

1. On first entry you should see a blank 6m Cylinder, this is our most popular structure and serves as a good starting point.
   Image Modified

1. To change to a different Igloo structure, you will need to move around the room. To do this, look at your controller, it will indicate the correct button to press to teleport around the room.
   Press and hold this button to create a teleport "jump", then let go to "jump" to the highlighted location.
   Image Modified
   
   Move towards a wall of pictures, which will illustrate each structure you can visualize. Move close and adjascent to a picture and hold out your controller until it the button turns yellow, then click the rear trigger on the controller to select that Igloo structure.
   Image Modified
2. You can also navigate further around the room to survey the entire Igloo structure, you are able to teleport to various locations, and even onto the 2nd floor within the room.
   Image Modified
   
   You can get a good view of your selected igloo structure from the 2nd floor!
   Image Modified

3. To play some content within the dome, navigate to the Input Selection board, near the wall of Igloos.
   Image Modified
   
   Spout inputs are Green, and the Warper Canvas is the Igloo Warper system. So to play your own content please select this.
   
   Image Modified
   
   NDI inputs are Blue, and can be pulled from anywhere on the local network. To test this functionality, download NDI Tools from this LINK and run the Test Patterns application.
   You will see the name of your desktop appear after a few short seconds, as a blue button.
   
   Image Modified

   Info
   Sometimes it does take between 5-10 seconds to both refresh the inputs list, and also set the active input. This is due to the program swapping plugins behind the scenes.

   
   

Keyboard Shortcuts

To help with development, and instances where you may not be using an Oculus Rift, or HTC Vive, we have created a debug mode where you can use the following keyboard commands, as well as your mouse, to move and interact with the IglooShowroom program.

...

...

On this page:

...