Controls when using a Headset

General Interactions

1. On first entry you should see a blank 6m Cylinder, this is our most popular structure and serves as a good starting point.
   Image RemovedImage Added

1. To change to a different Igloo structure, you will need to move around the room. To do this, look at your controller, it will indicate the correct button to press to teleport around the room.
   Press and hold this button to create a teleport "jump", then let go to "jump" to the highlighted location.
   
   
   Move towards a wall of pictures, which will illustrate each structure you can visualize. Move close and adjascent to a picture and hold out your controller until it the button turns yellow, then click the rear trigger on the controller to select that Igloo structure.
   
2. You can also navigate further around the room to survey the entire Igloo structure, you are able to teleport to various locations, and even onto the 2nd floor within the room.
   
   
   You can get a good view of your selected igloo structure from the 2nd floor!
   Image RemovedImage Added

3. To play some content within the dome,

   press the Oculus/Vive home button, and select the Desktop Viewer.
   This is built into both systems and allows the user to interact with their desktop using their VR controllers from inside the headset.
   Image Removed
   Pull Igloo control to the front, and select the content you would like to run. This will then play onto the Warper, which in turn will appear inside
   the Igloo structure you have active. Please note: switiching structure does not stop the playback.
   Image Removed

Controls without using a headset

General Interactions

On first entry you should see a blank 6m Cylinder, this is our most popular structure and serves as a good landing point.
Image Removed

Info
title Content
The black screen is just because no content is playing. When there is content playing you will be able to see it.

1. To change the structure to a different Igloo, navigate outside and look for the wall of pictures. You can then click on and select the igloo structure you would like to view in the show room.
   Image Removed
2. You can also roam around the room, to get a better idea of the structure and its dimensions.
   Image Removed
3. If you play a clip using the Igloo Control application, you will then be able to see it inside the structure.
   Image Removed

   navigate to the Input Selection board, near the wall of Igloos.
   Image Added
   
   Spout inputs are Green, and the Warper Canvas is the Igloo Warper system. So to play your own content please select this.
   
   Image Added
   
   NDI inputs are Blue, and can be pulled from anywhere on the local network. To test this functionality, download NDI Tools from this LINK and run the Test Patterns application.
   You will see the name of your desktop appear after a few short seconds, as a blue button.
   
   Image Added

   Info
   Sometimes it does take between 5-10 seconds to both refresh the inputs list, and also set the active input. This is due to the program swapping plugins behind the scenes.

   
   

Keyboard Shortcuts

To help with development, and instances where you may not be using an Oculus Rift, or HTC Vive, we have created a debug mode where you can use the following keyboard commands, as well as your mouse, to move and interact with the IglooShowroom program.

In addition to this guide, these commands are displayed in the active game window.