Controls when using a Headset

General Interactions

1. On first entry you should see a blank 6m Cylinder, this is our most popular structure and serves as a good landing point.
   

   Content

   The black walls are just because no content is playing. If there is some content playing you would be able to see it.

2. To change to a different igloo, you will need to move around the room. To do this, look at your controller, and it will indicate the correct button to press to teleport around the room.
   Press and hold this button to create a teleport jump, then let go to jump to the highlighted location.
   
   
   Move towards a wall of pictures which illustrate each dome you can view, move right up close to a picture, and hold out your controller until it the button turns yellow. Then click the rear trigger on the controller to select that igloo structure.
   
3. You can also navigate further around the room to survey the entire Igloo structure, you are able to teleport into a lot of locations, and even onto the 2nd level within the room.
   
   
   You can get a good view of your selected igloo structure from the 2nd floor!
   
4. To play some content within the dome, press the Oculus/Vive home button, and select the Desktop Viewer.
   This is built into both systems and allows the user to interact with their desktop using their VR controllers from inside the headset.
   
   
   Pull Igloo control to the front, and select the content you would like to run. This will then play on the Warper, which in turn will appear inside
   the igloo structure you have active. Switiching structure does not stop the playback.
   

Controls without using a headset

General Interactions

1. On first entry you should see a blank 6m Cylinder, this is our most popular structure and serves as a good landing point.
   

   Content

   The black walls are just because no content is playing. If there is some content playing you would be able to see it.

2. To change the igloo to a different igloo, navigate outside the igloo structure, and look for the wall of pictures. You can then click on and select the igloo structure you would like to view in the show room.
   
3. You can also roam around the room, to get a better idea of the structure, and its dimensions.
   
4. If you trigger a clip using the Igloo Control application, you will then be able to see it inside the structure.
   

Keyboard Shortcuts

To help with development, and instances where you may not be using an Oculus rift, or HTC Vive, we have created a debug mode where you can use the following keyboard commands, as well as your mouse, to move and interact with the IglooShowroom program.
In addition to this guide, these commands are displayed in the active game window.