Introduction
Igloo Setup is designed to be a starting point in the modelling pipeline of a used to generate configuration files for an Igloo installation, also known as a projection scene.
A projection scene specifies the geometry and properties of a set of screens in a given space.
A screen is defined by one of the following geometries - Planeplane, Disk, disk and Cylindercylinder.
| Info |
|---|
Note than screen dimensions should reflect the the area covered by the projection system. |
When starting the application, one is presented with an initial view illustrated in Figure 1. The layout is comprised The application starts up with the initial view illustrated below.
...
The user interface consists of four tabs - Screen, Canvas, Projectors , and Export, which are intended to be used sequentially. These represent the stages in the Igloo Settings Tool Setup modelling pipeline.
In most of the cases, these are designed to be used sequentially. For example, the Canvas tab needs the geometry of the projection scene which is specified in the Screen tab. Likewise, Projectors tab uses the canvas of the projection scene - defined in Canvas - to specify the projector regions and other attributes.
...
The Screen tab specifies the geometry of the projection scene.
| Info |
|---|
Note than the screen dimensions should reflect the the area covered by the projection system. |
The following geometries are supported:
...