...
The following command line arguments can be used
| argument | use |
|---|---|
| -igloo3DEnabled | Enables 3D Mode on start |
| -iglooSpoutReset | Enables sending a reset message '/spout/reset' via OSC on creation to port 9001 |
| -iglooSenderName |
| [NAME] | Where the following [NAME] argument specifies the spout sharing name |
| -iglooCameraType [NAME] | Where the following [NAME] argument specifies the type of camera and must be Cylinder Cube Unwrap Cylinder6 |
| -setNDI | Sets the output mode of all camera systems to NDI rather than Spout |
| -setResolution 7680,500 | RCR Labs only sets the resolution for the system. Default is 7680x500. |